It provides a pretty impressive cardiovascular workout that will leave you feeling rejuvenated and empowered at the same time. This is a water resistance model that allows you to smoothly cut through water using all the major muscle groups, without putting unnecessary strain on the lower back and joints. This is the perfect workout for users who cannot participate in high impact workouts.
Blades, otherwise known as oars to amateurs or non rowers, are used to propel the boat. They are long (sculling: 250–300 cm; sweep oar: 340–360 cm) poles with one flat end about 50 cm long and 25 cm wide, called the blade. Classic blades were made out of wood, but modern blades are made from more expensive and durable synthetic material, the most common being carbon fiber.

The horizontal movement of the water when a wave passes is approximately equal to the up and down movement of the water. If you are on flat water and are parallel to waves made by a passing boat, your boat will move side-to-side as much as up-and–down as the wave passes under you. The side-to-side movement actually creates most of the difficulty in balancing the boat in such a situation. However, under typical conditions in the bay there can be such varied wave action that you can’t easily distinguish horizontal and vertical motion.
The most commonly damaged piece of rowing equipment is the skeg, which is a metal or plastic fin that comes out of the bottom of the boat to help maintain stability, and to assist in steering. Since the skeg sticks out below the hull of the boat it is the most vulnerable to damage, however it is relatively easy to replace skegs by gluing a new one on. Hull damage is also a significant concern both for maintaining equipment, and for rower safety. Hull damage can be caused by submerged logs, poor strapping to trailers, and collisions with other boats, docks, rocks, etc.
The Challenge AR has the capability to allow the rower to control and adjust the resistance from “Feather light” to “Olympic sprint” delivering a silky smooth resistance to the user’s effort and instantaneous response to input with no “flat sport”.  With water resistance being the most accurate manner in which to simulate actual outdoor rowing, the Challenge AR provides a smooth and consistent sensation throughout the range of motion of the exercise experience.  

Rowing has long been recognized as the perfect aerobic pursuit, with naturally smooth and flowing movements that don't tax the joints but do boost the heart rate. Now you can take your rowing experience to the next level with the WaterRower Natural rowing machine. Using the same principles that govern the dynamics of a boat in water, the WaterRower Natural is outfitted with a "water flywheel" that consists of two paddles in an enclosed tank of water that provide smooth, quiet resistance, just like the paddles in an actual body of water. As a result, the machine has no moving parts that can wear out over time (even the recoil belt and pulleys don't require lubricating or maintaining). More significantly, the water tank and flywheel create a self-regulating resistance system that eliminates the need for a motor. As with real rowing, when you paddle faster, the increased drag provides more resistance. When you paddle slower, the resistance is less intense. The only limit to how fast you can row is your strength and your ability to overcome drag. And unlike conventional rowing machines, which tend to be jerky and jarring, the WaterRower Natural is remarkably smooth and fluid.
The fluid movement and sound of the WaterRower's dynamic WaterFlyWheel have been praised for lulling babies to sleep. The smooth, quiet, and unintrusive nature of our rowing machine allows for a workout not limited by time of day or proximity to others. Enjoy an indoor rowing exercise while watching television, or while another reads in the same room!
THL: Stay a safe distance from vertical surfaces if there are significant waves present in the area. A passing boat or ship may generate big waves that escape your attention until there is no time to escape. An example is the North anchorage of the Golden Gate Bridge (but there are special cases, e.g. rough water classes or the OWRC regatta, when there is a fast flood coming through the Golden Gate, and it is useful to be close to the wall since the current is slower there).
Most people who are new to the sport of rowing have difficulty achieving low strokes rates while trying to obtain their desired intensity – there are many comments such as “it does not feel hard enough?” or “how can I make it harder?” Rowing is about ratio and rhythm and you need to focus on a long stroke length and a powerful drive phase (push with the legs and pull with the arms). Give yourself time to learn this, it can take a few weeks before you start to feel the intensity at low stroke rates.
WaterRower Rowing Machines offer a pleasant rowing exercise while holding true to the dynamics of on-water rowing; burn up to 1000 calories an hour and work up to 84 percent of your muscle mass! Rowing provides an effective, high-intensity, cardio workout, while maintaining a low-impact to the joints. Workout at your own pace as the WaterFlyWheel's self-regulating resistance dynamically adjusts to each of your strokes. Unlike common ergometers, to change resistance on a WaterRower rowing machine you simply row harder!
First of all, if you're considering rowing, just do it. It is by far the most enjoyable and beneficial exercise I have ever tried. I've made huge strides with both cardio and muscle fitness with the WaterRower, and it's so enjoyable I look forward to exercising each day. Yes, it is more expensive than most other rowing machines, but when you compare it to a lot of other types of exercise equipment, it's actually pretty reasonable. When you also compare the exercise benefit you get, it's a bargain.
At the collegiate level (in the United States), the lightweight weight requirements can be different depending on competitive season. For fall regattas (typically head races), the lightweight cutoff for men is 165.0 lb. and 135.0 lb. for women. In the spring season (typically sprint races), the lightweight cutoff for men is 160.0 lb., with a boat average of 155.0 lb. for the crew; for women, the lightweight cutoff is 130.0 lb.[48]

Racing boats are stored in boat houses. These are specially designed storage areas which usually consist of a long two-story building with a large door at one end which leads out to a pontoon or slipway on the river or lakeside. The boats are stored on racks (horizontal bars, usually metal) on the ground floor. Oars, riggers, and other equipment is stored around the boats. Boat houses are typically associated with rowing clubs and include some social facilities on the upper floor: a cafe, bar, or gym.


The tank of the WaterRower Oxbridge Rower is made from polycarbonate, one of the strongest plastics available. It is virtually indestructible. The tank is sealed and can be filled with municipal water via a small opening closed by a stopper. This water typically contains enough chlorine to remain clear for some time. After exposure to light, the chlorine will degrade; the chlorine tablets should be added periodically.
This piece of finely tuned, hand-crafted, water-resistance workout equipment also sits at the top end of the rowing machine spectrum. Employing a water flywheel that helps to mimic the feel of rowing in actual water, the natural wood WaterRower Rowing Machine will bring you a smooth, yet challenging workout that is as tough as you want it to be. If rowing is one of the best exercises you can do for your body as far as natural motion with low to no-impact, then the WaterRower is one of the best machines to do it on.
By charter, the Schuylkill Navy’s object is "to secure united action among the several Clubs and to promote amateurism on the Schuylkill River."[23] Over the years, the group has had a role in certain ceremonial and state functions.[24] The success of the Schuylkill Navy and similar organizations contributed heavily to the extinction of professional rowing and the sport's current status as an amateur sport.[25]
Note: Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Some states do not allow the exclusion on limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Rowing machines were first used in Archaic Greece. Chabrias, an Athenian military general in 4th Century B.C., invented wooden rowing simulators for his inexperienced oarsmen. This enabled them to learn technique and timing before stepping foot on actual water crafts. And it must have worked — Chabrias successfully led numerous naval attacks against the Spartans.
The standard length races for the Olympics and the World Rowing Championships is 2 kilometres (1.24 mi) long; 1.5 kilometres (0.93 mi) - 2 kilometres (1.24 mi) for US high school races on the east coast; and 1,000 m for masters rowers (rowers older than 27). However the race distance can and does vary from dashes or sprints, which may be 500 metres (1,640 ft) long, to races of marathon or ultra-marathon length races such as the Tour du Léman in Geneva, Switzerland which is 160 kilometres (99 mi),[36] and the 2 day, 185-kilometre (115 mi) Corvallis to Portland Regatta[37] held in Oregon, USA. In the UK, regattas are generally between 500 metres (1,640 ft) and 2 kilometres (1.24 mi) long.
The WaterRower Natural rowing machine is handcrafted in solid ash wood, stained Honey Oak, and finished with Danish oil. Wood is an excellent material for this application due to its ability to absorb sound and vibration enhancing the WaterRower's smooth, quiet operation. The Natural, as with all WaterRowers, features patented WaterFlywheel technology, unrivaled in its replication of the resistance felt in on the water rowing.
Rowing machines were first used in Archaic Greece. Chabrias, an Athenian military general in 4th Century B.C., invented wooden rowing simulators for his inexperienced oarsmen. This enabled them to learn technique and timing before stepping foot on actual water crafts. And it must have worked — Chabrias successfully led numerous naval attacks against the Spartans.
Modern rowing as a competitive sport can be traced to the early 10th century when races were held between professional watermen on the River Thames in London, United Kingdom. Often prizes were offered by the London Guilds and Livery Companies. Amateur competition began towards the end of the 18th century with the arrival of "boat clubs" at the British public schools of Eton College, Shrewsbury School, and Westminster School. Similarly, clubs were formed at the University of Oxford, with a race held between Brasenose College and Jesus College in 1815. At the University of Cambridge the first recorded races were in 1827. Public rowing clubs were beginning at the same time; in England Leander Club was founded in 1818, in Germany Der Hamburger und Germania Ruder Club was founded in 1836 and in the United States Narragansett Boat Club was founded in 1838 and Detroit Boat Club was founded in 1839. In 1843, the first American college rowing club was formed at Yale University.
Row machine looks like it's a $600 unit. If you're in the market for a water rower I'd spend the money on the real Water Rower. I was wanting the Water Rower but after this poor experience I just want something that lasts and is warranted the longest. I purchased a concept2 that had arrived and is a much better quality unit. The computer is much better.
The main advantages of the water rower are that it has quiet operation; there is only little maintenance to do, the water only needs to be changed occasionally; many users love the whooshing sound of water in the tank; and its consistently smooth resistance at every stroke. Two disadvantages of this machine are it costs a lot than the air rower; and it tends to be larger in size compared to the other rowing machines.

The horizontal movement of the water when a wave passes is approximately equal to the up and down movement of the water. If you are on flat water and are parallel to waves made by a passing boat, your boat will move side-to-side as much as up-and–down as the wave passes under you. The side-to-side movement actually creates most of the difficulty in balancing the boat in such a situation. However, under typical conditions in the bay there can be such varied wave action that you can’t easily distinguish horizontal and vertical motion.

No matter the resistance we set or the power we applied, the machine remains sturdy, centered, and even. We amped up the intensity for 2000m sprints and found that the C2 supports consistent effort in a way water resistance can’t. The machine assists in keeping your intensity uniform, because it stores up remaining energy in the spinning flywheel. Comments about the ride feel of both Concept 2s were noticeably brief. As one tester put it, “It’s unremarkable because it’s good,” and leaves you free to focus on the effort you’re putting into your workout.

If you are accustomed to the natural catch and feel of on-water rowing, your rowing technique will immediately appreciate the Apollo’s unrivalled emulation of a boat gliding through water. FDF’s patented twin tank design generates a smooth uniform stroke, including no lag of resistance at the catch and continued resistance all the way to the finish.
The WaterRower Natural rowing machine is handcrafted in solid ash wood, stained Honey Oak, and finished with Danish oil. Wood is an excellent material for this application due to its ability to absorb sound and vibration enhancing the WaterRower's smooth, quiet operation. The Natural, as with all WaterRowers, features patented WaterFlywheel technology, unrivaled in its replication of the resistance felt in on the water rowing.

The WaterRower Natural is handcrafted in solid ash and stained honey oak for consistency of color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil to provide a deep luster.
The WaterRower Natural is handcrafted in solid ash and stained honey oak for consistency of color. The wood was chosen due to its marvelous engineering properties, especially its ability to absorb sound and vibration, which enhances the WaterRower's quiet performance and smooth operation. Ash, like all woods used in the construction of the WaterRower, is a premium hardwood with incredible longevity and dimensional stability. In addition, the wood is harvested from replenishable forests and is hand finished with Danish oil to provide a deep luster.
In sweep or sweep-oar rowing, each rower has one oar, held with both hands. This is generally done in pairs, fours, and eights. In some regions of the world, each rower in a sweep boat is referred to either as port or starboard, depending on which side of the boat the rower's oar extends to. In other regions, the port side is referred to as stroke side, and the starboard side as bow side; this applies even if the stroke oarsman is rowing on bow side and/or the bow oarsman on stroke side.
×